Power UNITS FOR LIFT TABLE one
Basic Description
This electrical power unit is developed exclusively for your modest lift table,Consisting of large pressure gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This electrical power unit has been extensively employed within the field of logistic devices such as minifork lift, scissors lift and ariel doing work platforms. The lower-ing movement is managed from the solenoid valve together 
with the pace managed from the adjustable needle valve.
Electrical power UNITS FOR LIFT TABLE 2
General Description
This electrical power unit is created solely to the medium lift table, Consisting of extremely effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The decreasing motion is actived by the solenoid valve as well as velocity controlled from the adjustable needle valve. Once the lift rises to a high positoin, however the energy supply is lower, the reducing movement is managed by the guide override perform.
Power UNITS FOR LIFT TABLE three
General Description
This electrical power unit is developed exclusively to the large lift table, Consisting of hugely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing movement is actived from the solenoid valve as well as speed managed by a stress compensated movement management valve.
Electrical power UNITS FOR LIFT TABLE 4
Common Description
This power unit is created solely for that massive lift table, Consisting of highly effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering movement is actived by the solenoid valve as well as the velocity managed by the adjustable needle valve. Once the lift rises to a substantial positoin, but the electrical power supply is reduce, the reducing movement is managed through the guide override perform.
Unique Notes
1. This energy unit is of S3 duty cycle, which can only function intermittently and repeatedly, i.e. one minute on and 9 minutes off.
2. Clean all the hydraulic elements concerned in advance of set up of the energy unit.
three. Viscosity with the oil shoud be 15~46 cst,which must also be clean and absolutely free of impurities.N46 hydraulic oil is advised.
four. Oil changing is needed after the preliminary 100 operation hrs,afterwards as soon as every single 3000 hours.
five. The electrical power unit proven is built to be mounted vertically.
