ep

January 22, 2021

SMR Gearbox Installation
Satisfactory efficiency is determined by right installation. lubrication and servicing. thus it is necessary the instructions within the set up and servicing leaflet. provided with every gearbox. are followed carefully. a number of the vital elements of belt and torque-arm set up are listed under.
1. Install pulley on gearbox input shaft as shut for the reducer achievable, and mount reducer on driven shaft as near to bearing as sensible. failure to perform this will cause excess loads from the input shaft bearings and output bearings and could result in their premature failure.
2. Install motor and wedge belt drive using the belt pull at around 90° for the center line among driven and input shafts. this will likely permit tensioning of your wedge belt drive with all the torque arm which need to preferably be in stress. if output hub runs anti-clockwise. torque arm must be positioned the correct.
three. lnstall torque-arm fulcrum on the rigid assistance in order that the torque-arm will probably be at approximately appropriate angles to your center line through the driven shaft as well as the torque arm case bolt. ensure there is adequate get up while in the turnbuckle for belt tension adjustment.
Preserve shut.
Bell drive can be located in any practical postion. should the torque arm is to be used to tighten the belts, the drive ought to be at about tight angle towards the line amongst the input and output shafts.
Bell drive may be located towards the proper if preferred.
If output hub rotates clock-wise. place belt drive and torque arm in opposite direction to that proven during the illustration.
Torque arm and belt take up.
Torque arm might be mounted to your appropriate if sought after.